Electrical • Nominal Battery Voltage: 12V or 24V • Battery Voltage Range: 10-35V • Voltage Accuracy: <= 0.1% +/- 50mV • Maximum Battery Current: 15A • Maximum Solar Input Voltage: 60Voc • Load Current Rating: 15A • Self-Consumption: 20 mA w/o meter • LED Indications: (1) status, (3) Battery state of charge • Transient Surge Protection: 1500 Watts (solar, battery, load) Environmental • Operating Temperature: -40°C to + 60°C • Meter Operating Temperature: -20°C to + 60°C • Storage Temperature: -40°C to + 80°C • Humidity: 100% non-condensing Meter (15M Version) • Resolution: 128 X 64 pixels • Viewing Area: 5.0 cm x 2.5 cm • Display Color: Blue on white • Backlight: LED • Tropicalization: conformal coating, marine-rated terminals Battery Charging • Battery Types: 7 Standard Battery Settings + Custom • 4-Stage Charging: Bulk, Absorption, Float, Equalize • Temperature Compensation • Coefficient: -5 mV / °C / cell (25°C ref) • Range: -30°C to + 60°C • Set Points: Absorption, Float, Equalize | ProStar Gen 3 charge controller simple wiring diagram review. Mechanical • Dimensions: 15.3(W) x 10.5(L) x 5.5(D) cm 6.0(W) x 4.1(L) x 2.2(D) in • Weight: 0.4 kg / 1.0 lbs • Wire Size Range: Power Terminals: 2.5 - 16 mm2 / 14 - 6 AWG Battery/Temp. Sense: 0.25 - 1.0 mm2 / 24 - 16 AWG • Enclosure: IP20, Type 1 Electronic Protections • Solar Input: overload, short-circuit, high voltage, reverse polarity, high temperature, nighttime reverse current • Load Output: overload, short-circuit, high temperature, reverse polarity • Battery: reverse polarity (no battery removal) ProStar 15 Gen 3 Accessories Load & Lighting Control • Low Voltage Disconnect, Low Voltage Reconnect Settings: 11.4 V / 12.6 V or Custom (x2 for 24 volt systems) • Lighting Settings: Dusk to Dawn or Custom • LVD Current Compensation: -20 mV per Amp @ 12 Volts / -40 mV per Amp @ 24 Volts • LVD Warning Timer: 10 minutes • Lighting Test Timer: 5 minutes Accessories • Remote Temperature Sensor (RTS) • Remote Meter (RM-1) • PC MeterBus Adapter (MSC) • USB Communications Adapter (UMC-1) • Ethernet Communications Adapter (EMC-1) • Meter Hub (HUB-1) • Relay Driver (RD-1) • Ground Fault Protection Device (GFPD-150) |